作者：余晓峰1, 邢乐2, 李兆旭3, 戴焱雄2, 徐万海3
作者单位：1. 国家管网集团工程技术创新有限公司，天津 300000;
2. 中国寰球工程有限公司北京分公司，北京 100012;
3. 天津大学 水利工程智能建设与运维全国重点实验室，天津 300072
关键词：lng薄膜板;残余应力;x射线衍射;波纹结构;不锈钢板
摘要：
该文旨在利用x射线衍射法对mark iii型lng（liquefied natural gas，液化天然气）薄膜板进行残余应力检测，以期获得其残余应力分布规律及典型特性。通过布置16个测点，测试不同方向和区域的残余应力特性。结果显示：大波纹和小波纹交叉节点顶部受压，最大压应力可达178 mpa；板面平直区域呈现压应力，大波纹波峰处受拉，拉应力峰值为115 mpa，小波纹波峰处残余应力受板的边界影响而有所增大。研究工作对于lng薄膜板的使用、设计和维护具有重要指导意义，可为工程实践提供有益参考，为lng薄膜板的进一步优化和自主国产化提供重要依据。
residual stress detection and characteristic analysis of lng membrane panel based on x-ray
yu xiaofeng1, xing le2, li zhaoxu3, dai yanxiong2, xu wanhai3
1. pipechina engineering technology innovation co., ltd., tianjin 300000, china;
2. china huanqiu contracting and engineering (beijing) co., ltd., beijing 100012, china;
3. state key laboratory of hydraulic engineering intelligent construction and operation, tianjin university, tianjin 300072, china
abstract: this paper aims to utilize x-ray diffraction (xrd) method to investigate the residual stress in mark iii type lng (liquefied natural gas) membrane panels. a residual stress analyzer was employed to examine the residual stress distribution and characteristics of the membrane panels. sixteen measurement points were arranged to analyze the residual stress in different directions and areas. the nodes are under compression and the maximum compressive stress can reach 178 mpa; the flat surface regions exhibit compressive stress, while the peaks of the large and small corrugations experience tensile stress, the maximum tensile stress is 115 mpa. the findings of this research provide valuable guidance for the utilization, design, and maintenance of lng membrane panels, reducing the risk of structural failure and enhancing stability and reliability. these discoveries offer beneficial insights for future engineering practices, offering crucial support for further optimization and application of lng membrane panels.
keywords: lng membrane panel;residual stress;x-ray diffraction;corrugated structure;stainless steel plate
2024, 50(8):72-78 收稿日期: 2024-04-03;收到修改稿日期: 2024-05-09
基金项目: 国家自然科学基金项目（51979193）；国家石油天然气管网集团有限公司科学研究与技术开发项目（sjsg202207）
作者简介: 余晓峰（1978-），男，河南汝州市人，正高级工程师，博士，主要从事石油天然气相关的结构设计。
参考文献
[1] 刘爱虢, 陈欣, 陈保东, 等. 液化天然气作为航空燃料的发展趋势及特点分析[j]. 航空动力学报, 2016, 31(6): 1281-1288.
liu a g, chen x, chen b d, et al. analysis of the development trend and characteristics of liquefied natural gas as aviation fuel[j]. journal of aerospace power, 2016, 31(6): 1281-1288.
[2] 赵杰. 液化天然气(lng)的制备与储存运输[j]. 当代化工研究, 2023(24): 174-176.
zhao j. preparation and storage transportation of liquefied natural gas (lng)[j]. contemporary chemical industry research, 2023(24): 174-176.
[3] 李星. lng低温储罐开发技术研究[j]. 化工管理, 2024(5): 83-86.
li x. research on development technology of lng low-temperature storage tanks[j]. chemical engineering management, 2024(5): 83-86.
[4] 张丹, 许佳伟, 明红芳, 等. lng薄膜罐技术发展现状及其在国内推广的前景[j]. 化工管理, 2021(5): 9-10.
zhang d, xu j w, ming h f, et al. current development status of lng membrane tank technology and its prospects for domestic promotion[j]. chemical engineering management, 2021(5): 9-10.
[5] tobita h, tanigawa m, abiko r, et al. a study on the reduction of corrugations in the gtt mark iii type membrane[j].
[6] 巴发海, 刘宇希. 残余应力的表征[j]. 无损检测, 2020, 42(10): 1-3.
ba f h, liu y x. characterization of residual stress[j]. nondestructive testing, 2020, 42(10): 1-3.
[7] 王建军, 李宏光, 王庆超, 等. 钢轨中残余应力的产生、影响及调控研究现状[j]. 燕山大学学报, 2024, 48(1): 1-10.
wang j j, li h g, wang q c, et al. research status on generation, influence, and control of residual stress in steel rails[j]. journal of yanshan university, 2024, 48(1): 1-10.
[8] 程勇杰, 王燕霜, 林江海, 等. 表面残余应力影响因素和调控技术的研究进展[j]. 表面技术, 2022, 51(11): 138-152.
cheng y j, wang y s, lin j h, et al. research progress on influencing factors and control techniques of surface residual stress[j]. surface technology, 2022, 51(11): 138-152.
[9] park s y, kim w t, choi j h, et al. effects of process-induced residual stress and geometric characteristics on pressure-resisting capability of corrugation in primary barriers of liquefied natural gas carriers[j]. ocean engineering, 237, 109613.
[10] lee d, kim k h, choi i , et al. pressure-resisting capability of the knot area of the primary barrier for an lng containment system[j]. ocean engineering, 1995:128-133.
[11] oh d j , kim n k , song s w , et al. investigation of fatigue performance for new membrane-type lng ccs at cryogenic temperature[j]. marine structures, 1962:90-105.
[12] kim y k, oh b t, hong s h, et al. the performance test of kogas membrane for applying the large-scale lng storage tank[c]//isope international ocean and polar engineering conference. isope, 2004: isope-i-04-416.
[13] 王晓光, 刘柯, 郭天茂, 等. 基于光栅扫描焊接残余应力轮廓法测量技术研究[j]. 中国测试, 2022, 48(12): 35-39.
wang x g, liu k, guo t m, et al. research on measurement technology of residual stress profile method based on grating scanning welding[j]. china measurement & test, 2022, 48(12): 35-39.
[14] 戴宗贤, 赵磊, 张朕滔, 等. 金属材料塑性损伤的多物理场融合检测方法[j]. 中国测试, 2022, 48(7): 30-36.
dai z x, zhao l, zhang z t, et al. multiphysics fusion detection method for plastic damage of metal materials[j]. china measurement & test, 2022, 48(7): 30-36.
[15] 成志强, 李荣光, 李璐, 等. 基于x射线衍射的在役全尺寸管道应力测试方法[j]. 中国测试, 2023, 49(10): 7-12.
cheng z q, li r g, li l, et al. stress test method for in-service full-scale pipeline based on x-ray diffraction[j]. china measurement & test, 2023, 49(10): 7-12.
